New & refurbished controls with automatic buying portal for a fixed price ECL Danfoss ECL Danfoss ECL Heizde Danfoss ECL Danfoss Ecl Manual. User’s Guide. Before you start. Save energy – save money – improve your comfort temperature. The ECL Comfort controller is designed by Danfoss for the.

Author: Marr Tohn
Country: Latvia
Language: English (Spanish)
Genre: History
Published (Last): 22 March 2012
Pages: 355
PDF File Size: 7.63 Mb
ePub File Size: 5.97 Mb
ISBN: 960-2-94473-656-8
Downloads: 23450
Price: Free* [*Free Regsitration Required]
Uploader: Bragore

No, I do not send my defective items back.

Setting the compensation temperature value 1. How are the connections to ECA 32?

Choose manual operation as controller mode. Application A, addresses numbers 1 and 2. Set Start2 and Stop2 times to the same time value. The desired room temperature is adapted danfosx. The outdoor temperature sensor must be connected to the base part of the master controller.

Completely refurbished and functionally tested by Heiz24 specialists. Weather compensated flow temperature control of heating and boiler systems.

Heiz24 – the Specialists in new and refurbished Controls | refurbished | Danfoss ECL

This symbol indicates that this particular piece of information should be read with special attention. The setting should be kept as high as acceptable to increase the lifetime of the valve actuator. ECL does not show actual temperatures. P1 Post-run This limitation is because of the power demand from each ECA Fcl Maintenance Service Code no. Choose “ECA communication” d.


The display shows an application related elc. The Master controller has address 15 from the factory, so it does not need to be addressed. Select Control Mode The ECL Comfort adjusts the desired flow temperature to compensate for the difference between the desired and the actual room temperature.

ECL controllers

The pulses from the flow meter are applied to the Danfos 32 module’s pulse input. When the temperature, measured by S1, falls below or gets higher than the set compensation value, the ECL Comfort changes the desired flow temperature.

There are no blinking lights or arrays of buttons and switches, but the possibilities are unlimited. Limitation, Maximum Placing The Temperature Sensors Place the sensor max.

With the ECL controller or ECA remote control unit, all navigation and interaction take place by turning and pushing the dial on the front panel.

Page of 44 Go. Select “ECL addr. If the controller is not new from factory, do following: Page 2 The warning sign is used to emphasize special conditions that should be taken into consideration.


Limitation, Minimum Backlight display Brightness Based on the shown standard systems, it is possible to configure additional systems. Page 43 The time bars illustrate scheduled periods with comfort temperature. Then create the return ticket online, print it, stick it to the DPD package and deliver it to the nearest DPD station free of charge. Activation Time Gear Motor Via the ECL bus the T. The unit “ohm” expresses the electric resistance.

It is therefore necessary to manually check and reset the ECL addresses of slave controllers after this function has been elc.